Atomic Cluster Nuclear Fusion

The energetic laser–cluster interaction has opened the door to nuclear fusion? experiments using table-top laser systems operating at high repetition rates. The D + T -> n + He4 reaction has by far the largest cross-section for the range of ion energies accessible in laser–cluster experiments, but tritium poses a serious radiological hazard and so the D–D reaction has been investigated instead. Half the D–D fusion events follow the D + D -> n(2.45 MeV) + 3He reaction, which is convenient for study since the neutron can escape the inter- action chamber and, being of well-defined energy, can be identified unambiguously through TOF measurements.

The first definitive observation of a cluster based fusion reaction was reported in 1999 [68]. A dense D2 cluster target was irradiated with a 35 fs, 200 mJ laser pulse from a Ti:S CPA system. In the target, deuterons ejected from different clusters collide with sufficient energy (multi-keV) to trigger fusion events. The low value of the condensation parameter, k, for D2 requires it to be cooled below 80 K to allow large cluster formation. Around 50,000 neutrons were observed per shot (at a repetition rate of 10 Hz), which is a relatively large number when normalized to the input laser energy. In contrast to high Z clusters (Ar, Kr, Xe), D2 clusters can be stripped of almost all their electrons by a sufficiently short laser pulse (<50 fs is required). Hence a Coulomb explosion picture, rather than a nanoplasma model is appropriate. For a fully stripped D2 cluster of radius r, the maximum ion energy from the Coulomb explosion is given by

formula (9) page 321, TD69.pdf

where nD is the initial ion density (~3 x 1022 cm-3 for D2). From this it can be calculated that a D2 cluster of radius r > 2.5 nm is required to produce multi-keV deuterons necessary for fusion. A detailed description of this work can be found in [69].

Modelling of the neutron yield within this Coulomb explosion picture has been carried out [70] providing good agreement with the experimental data, and a comparison with the case of a hydrodynamic cluster expansion is given in [71].

Also, direct measurements of proton energies up to 7 keV from exploding hydrogen clusters have been made [72], showing a combination of Coulomb explosion and hydrodynamic? mechanisms for somewhat longer laser pulses (90 fs).

Fusion in clusters has attracted considerable interest because it provides a pulsed source of neutrons of a small source size. The neutron pulse duration is basically set by the time taken for an energetic deuteron to leave the laser focus, and has been measured to be less than 500 ps [73], which is considerably shorter than Z-pinches and spallation? devices. A number of schemes have been proposed to increase the number of neutrons per laser shot. The use of mixed species (or heteronuclear?) clusters comprising deuterium and a higher Z atomic species (e.g. DI, D20, CD4) is likely to increase the deuteron explosion? energies and hence the neutron yields owing to the presence of the higher ionic charge [74–76]. A further advantage is that many of these molecular gases have much larger condensation parameters than D/2 , eliminating the need for cryogenic cooling to produce large clusters. Another scheme recently demonstrated is the ‘‘machining’’ of a clustered gas jet target using a second laser pulse [77] to disassemble clusters in the lower density entrance wing of the jet, ahead of the arrival of the main heating pulse. By reducing absorption in this wing – known to limit the fusion yield [69] – this has been shown to significantly increase the deposition of laser energy in the high density, central part of the gas jet. A significant increase in both the number of neutrons per shot, and the pulse repetition rate of the neutron source (1 kHz is already feasible) is likely to usher in applications of this table-top source, including short pulse neutron imaging, material probing and long term testing of materials under high fluxes of neutrons.

See Also

3.14 - Vortex Theory of Atomic Motions
13.04 - Atomic Subdivision
Atomic Cluster Application
Atomic Cluster Charge build-up
Atomic Cluster Expansion
Atomic Cluster Experimental Apparatus
Atomic Cluster Heating
Atomic Cluster Ionization
Atomic Cluster X-Ray Emission
Atomic Clusters
Atomic Force
atomic mass
atomic number
atomic theory
atomic triplet
atomic weight
Figure 13.06 - Atomic Subdivision
Formation of Atomic Clusters
Interaction of Intense Laser Pulses with Atomic Clusters - Measurements of Ion Emission Simulations and Applications TD69.pdf
Ion Energies from Atomic Cluster Explosions
Laser Cluster Interactions
Law of Atomic Dissociation
Law of Atomic Pitch
Law of Oscillating Atomic Substances
Law of Pitch of Atomic Oscillation
Law of Variation of Atomic Oscillation by Electricity
Law of Variation of Atomic Oscillation by Sono-thermism
Law of Variation of Atomic Oscillation by Temperature
Law of Variation of Atomic Pitch by Electricity and Magnetism
Law of Variation of Atomic Pitch by Rad-energy
Law of Variation of Atomic Pitch by Temperature
Law of Variation of Pitch of Atomic Oscillation by Pressure
Models of Laser Cluster Interactions
Numerical Simulation of an Atomic Cluster Explosion

Page last modified on Wednesday 05 of June, 2013 03:24:49 MDT

Search Wiki PageName

Recently visited pages